Monogram ZDIS150 Instruções de Operação descarregar pdf (Página 13)

Care and Cleaning

Icemaker

Light bulb

replacement

The icemaker has a light bulb in the top of the

storage bin. To replace it, open the bin door and

follow these instructions:

1. Unplug the icemaker or disconnect power.

2. Remove the 2 screws that hold the cutter grid

cover in place. Reach behind the control panel

and pull the light bulb down.

S. Replace with a 12-volt wedge base-tupe

bulb (automotive #917). Locate the light bulb

receptacle at the top behind the control

panel. Align the flat edge of the light bulb

with the receptacle and snap the bulb

into place.

4. Replace the cutter grid cover with the

2 screws.

5. Plug in the icemaker or reconnect poweE

Vacation

and moving

To shut down the icemaker:

1. Unplug the icemaker or disconnect power.

2. Remove all ice from the storage bin.

3. Shut off the water supplu.

4. Remove the 2 screws in the lower access

panel and the 2 screws from the base grille

area of the front panel support. Pull forward

to remove the lower access panel.

5. Disconnect the inlet and outlet lines to water

valve, Allow these lines to drain and then

reconnect to the valve.

6. Replace the lower access panel and screws.

Drain water from water reservoir by removing

the drain cap. Also, remove water from drain

line. Leave the door open to allow the

icemaker and water reservoir to dru out

completelu.

7. Before using again, clean the icemaker and

storage bin.

IMPORTANT: Every time the icemaker is turned

off, you MUSTclean the icemaker system with

the Nickel Safe Ice Machine Cleaner. See Core

ond Cleaning--lcemoker sgstem section for

instructions.

8. Plug in the icemaker or reconnect power.

NOTE: All components of the icemaker are

permanentlu lubricated at the facto%. They

should not require ang additional oiling

throughout the normal life of the machine.

Reverse

Osmosis

sgstem

IMPORTANT: The performance of the icemaker

may be affected when connected to a Reverse

Osmosis sgstem. An RO sgstem mag also reduce

water pressure and affect the fill cgcle, which is

dependent on time and flow. The reduced water

pressure may cause the reservoir not to fill and

flush properly during the ice making cycle.

The pressure of the water suppl U coming out

of a reverse osmosis system going to the water

inlet valve of the icemaker needs to be between

30 and 120 psi.

If a reverse osmosis water filtration system is

connected to uour cold water supplu, the water

pressure to the reverse osmosis system needs

to be a minimum of 40 to 60 psi. The reverse

osmosis system must provide 1 gal. of water

per hour to the icemaker for proper icemaker

operation.

Do not use copper tubing when the icemaker is

connected to a Reverse Osmosis water sgstem.

13

1 2 ... 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários