Monogram ZDP30N4 Manual do Proprietário

GE Monogram®InstallationInstructionsProfessionalRanges48" Natural Gas ModelsZDP48N4GZDP48N6RZDP48N6D48" LP Gas ModelsZDP48L4GZDP48L6RZDP48L6

10InstallationProfessional RangesWood Construction:•Place the bracket against the back wall, into theright rear corner of the installation location.•S

30" Wide Models:Rigid pipe is factory installed from theregulator to the bottom rear of the range.Flexible line may be used to connect to thepipe

12InstallationProfessional Ranges6ConnectElectricalPlug power cord into properly groundedreceptacle.Slide theRangeIntoPosition7•Carefully, slide the r

13InstallationProfessional Ranges9Assemble& AdjustBurners•Replace the burner bowls and burner caps.•Adjustments should not be required, unlessvibr

14NotesProfessional Ranges

15NotesProfessional Ranges

Pub. No. 49-8814-5Dwg. No. 164D3333P058(N.D. 728) 3/0310658 Rev. 7Note: While performing installations described in this book,safety glasses or goggle

2Before you begin—Read these instructions completely and carefully.IMPORTANT: Save these instructions for local inspector’s use.IMPORTANT: OBSERVE ALL

3Design InformationProfessional RangesModelsAvailableThese ranges are factory set for either naturalgas or liquid propane gas. Order the modelfor your

4Design InformationProfessional RangesProductDimensions& Clearances36" Wide Range Models48" Wide Range Models21-1/4"12"1-1/2&q

5Design InformationProfessional RangesProductDimensions& Clearances3-1/4"18" Min.30"/36" Wide Models 4"48" Wide Mode

6Design InformationProfessional RangesAdvancePlanningRefer to “Dimensions and Clearances” forappropriate placement and necessary clear-ances when pla

7Installation PreparationProfessional RangesGas Supply:•The natural gas models are designed tooperate at 6" to 14" water column pressure.•Th

8InstallationProfessional RangesBefore moving the range indoors:•Remove outer carton and packing materialfrom the shipping base.RemovePackaging1Step•R

36" and 48" Wide Models:•Remove the panel from the rear of theshipping pack. Lay the panel on the floordirectly in front of the installation